Manual

3
For the USA
FEDERAL COMMUNICATIONS COMMISSION RADIO
FREQUENCY INTERFERENCE STATEMENT
This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to Part 15
of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a resi-
dential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harm-
ful interference to radio communications. However, there
is no guarantee that interference will not occur in a particu-
lar installation. If this equipment does cause interference
to radio or television reception, which can be determined
by turning the equipment off and on, then the user is en-
couraged to try to correct the interference by one or more
of the following measures:
Re-orient or relocate the receiving antenna.
Increase the separation between the equipment and
the receiver.
Connect the equipment into an outlet on a circuit
different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV
technician for help.
Unauthorised changes or modification to this system can
void the users’ authority to operate this equipment.
This equipment requires shielded interface cables in order
to meet FCC class B limit.
For Canada
CLASS B NOTICE
This digital apparatus does not exceed the Class B limits
for radio noise emissions set out in the Radio Interference
Regulations of the Canadian Department of Communica-
tions.
CLASSE B AVIS
Cet appareil numérique ne dépasse pas les limites de la
classe B au niveau des émissions de bruits radioélectriques
fixés dans le Règlement des signaux parasites par le
ministère Canadien des Communications.
DRAWMER
D-Clock
DMS-2
WORD CLOCK MEASUREMENT
AND DISTRIBUTION AMPLIFIER
SAFETY CONSIDERATIONS
CAUTION - MAINS FUSE
TO REDUCE THE RISK OF FIRE
REPLACE THE MAINS FUSE ONLY WITH
A FUSE THAT CONFORMS TO IEC127-2.
250 VOLT WORKING, TIME DELAY TYPE
AND BODY SIZE OF 20mm x 5mm.
THE MAINS INPUT FUSE MUST
BE RATED AT T315mA.
CAUTION - MAINS CABLE
DO NOT ATTEMPT TO CHANGE
OR TAMPER WITH THE
SUPPLIED MAINS CABLE.
CAUTION - SERVICING
DO NOT PERFORM ANY SERVICING.
REFER ALL SERVICING TO QUALIFIED
SERVICE PERSONNEL.
WARNING
TO REDUCE THE RISK OF FIRE OR
ELECTRIC SHOCK DO NOT EXPOSE
THIS EQUIPMENT TO RAIN OR MOISTURE.