Installation Guide

©2018 DreamLine. All Rights Reserved
13DreamLine SHCM-3300 Shower Panel manual Ver 1 07/2018
Product Maintenance
Troubleshoo�ng
Cleaning materials for faucets and showers:
To avoid damage, it is necessary to use caution
when cleaning. Damage caused by improper
treatment is not covered under the warranty.
To remove limescale, use only products made
specifically for that purpose. Always follow the
manufacturer’s instructions.
Do not use cleaners that contain hydrochloric,
formic, acetic or phosphoric acids, as these will
cause considerable damage to finishes and to
plastic components.
Never mix cleaning materials.
Never use cleaners containing abrasives. Do not
use abrasive cleaning cloths, pads or sponges.
Cleaning Procedures:
Clean your faucets and shower products as necessary.
Regular cleaning will prevent limescale buildup and
water spotting.
Follow the instructions. Do not allow any cleaner to
remain on the product for longer than necessary.
When using spray cleaners, first spray onto a sponge
or cloth - do not spray directly onto the product.
After cleaning, rinse thoroughly with clean water to
remove any residue left behind.
Important:
Soap and shampoo residue can also cause damage to
the product. Rinse well with clean water after each
use.
If the surface is already damaged, harsh cleaning may
cause further damage.
Problem Possible Cause Remedy
Insucient water Supply pressure inadequate Check water pressure. If a pump has
been installed, check to see if the
pump is working.
Filters on thermostat cartridge dirty Clean thermostat ters
Washer screen dirty Clean
screen
washer between
shower and hose
Crossow: hot water
being
forced into
cold water pipe or vice versa when
mixer is closed
Check valves dirty or leaking Clean check valves replace if
necessary
Output temperature does not
correspond with temperature se
Handle not calibrated Calibrate handle
Hot water temperature too low Reset high temperature limit stop
Temperature regula not possible
Temperature regulator dirty or
ed
Clean temperature regulator replace
if necessary
Supply lines are cross-connected
Connect supply hoses to correct
Hot and Cold inputs
Safety stop override buon not

Spring worn out or defve Clean spring and or buon, replace if
necessary
Buon calcied
Diverter control s
Diverter cartridge dirty or defve Clean or replace cartridge