Installation Guide
Product Maintenance
©2018 DreamLine. All Rights Reserved
14DreamLine SHCM-3300 Shower Panel manual Ver 1 07/2018
Fig 14
Pressure
balanced
mixing valve
Diverter
Valve
HARDWARE: To ensure a long-lasting finish, wipe off the metal components after each use with a soft
cloth. Do not use abrasive cleaners or cleaning products containing ammonia, bleach or acid. If
accidentally used, rinse the surface as soon as possible to prevent peeling or corrosion of finish. After
cleaning the finished surfaces, rinse thoroughly with clean water and wipe dry with a soft cloth. Never
use an abrasive sponge or cloth, steel wool or wired brushes as these may permanently scratch the
surface.
NOTE: If the water in your area contains rust, salt, lime or other minerals or contaminants, you’ll want
to inspect your valve assembly regularly. The frequency for this will vary depending on the amount of
contaminants in the water. Remove the cartridges and inspect them. Flush them with clean water,
using a toothbrush when needed to remove any buildup. Striking the cartridge against the palm of
your hand can also help loosen unwanted contaminants. Fig 14
Operag pressure:
ow rate of 70 psi)
Max 102 psi
60-80 psi
120° F
176° F
2 gpm
Hand shower:
Recommended pressure:
Max Hot water temperature:
Recommended hot water temperature:
Technical Data Sheet