Installation Guide

8DreamLine SHCM-3300 Shower Panel manual Ver 1 07/2018

Fig 5

Wall

Fig 6

Mark bottom edge position of the

lower metal support on wall. Add the

distances (B)+(D)= Distance from floor

to bottom of lower metal support

Mark the bottom edge position of upper

metal support on wall. Add (B)+(D)+(X)=

Distance from floor to bottom edge of

upper metal support

(X)

(B)

(D)

Shower Floor

Measure/confirm distance (X) between

bottoms of metal supports (see page 10

or refer to Table 1 on Page 5 for

dimensions) in order to mark the wall for

installation of Support Brackets (#02)

6. Place the Support Brackets (#02) just below the lines you just made on the wall, with the bend of the

brackets lying on the marks as shown. Mark the screw holes. Drill the holes using a Ø 5/16” drill bit.

Insert the wall anchors and use the included screws to attach the Support Brackets (#02) to the wall.

(Fig 6)

5. Measure the distance between the bottom edges of the two metal supports on the back of the shower

panel (X). This dimension is also provided by the manufacturer on page 10 for comparison. Measure

from the bottom of the unit to the bottom of the lower support (D). Using a level, draw two small lines

on the wall to indicate the bottom edge of each metal support. (Fig 5)