Owner's manual

instructions
FOOTREST PAD
SWIVEL SHAFT
TENSION KNOB
FOOTREST PLATE
PLASTIC COVER
HINGE
CONNECTING TUBE
TUBE
PAD
COUNTER
RING
1. Remove contents from box.
2. Pull legs in opposite direction until locking button “snaps”
into locking receiver. (see figure A).
To close, pull locking ring and bend leg down. Repeat on
other leg (see figure B).
3. Insert tension knob on top of peddler and turn clockwise to
tighten. The tension knob will increase/decrease the amount
of tension on the peddler. Tighten/loosen to a level that feels
comfortable.
figure A
figure B
automatic operation
1. MODE (Red Button): This control allows you to select a
particular function. To start, press and hold the Red Button
for 4 seconds. The LED will display the different functions. (If
after tuning on and there in no activity, the unit will
automatically shut off).
2. To select a function, wait until the 4 second set up is
complete. Push the Red Button and the arrow will move
through the functions. When the desired function is selected,
simply use the peddler and the unit will calculate the
exercise.
3. TIME: Determines the amount of time the peddler has been
operating.
4. COUNT (CNT): Determines the amount of steps while
operating the peddler.
5. CALORIE (CAL): Determines the amount of calories burned
while using the peddler.
6. REPS PER MINUTE (R.P.M.) Automatically calculates the
repetitions per minute.
7. SCAN: Will automatically review the results of all functions.
battery replacement
If the display does not come on or reads incorrectly, the battery
requires replacement.
To replace the battery, use a small screw driver and remove
the display panel. Turn the display panel over and remove the
watch- style battery. Insert a new battery and replace the dis-
play panel.