POWER WHEELCHAIR Sunfire Plus EC OWNER’S MANUAL
TABLE OF CONTENTS 1. PREFACE AND INTRODUCTION..…………………………………… 2. SAFETY NOTICE………..…………………….................……… …………. 3 Before driving While driving Labeling 3. EMI……………………………………………..……………………………….. 8 4. PARTS INTRODUCTION……………………………………………..………. 9 5. OPERATION………………………………………………………………….... 10 6. 2 Joystick and controller How to operate your power wheelchair How to set to freewheel mode BATTERY CHARGING AND CARE……………………………………….....
1. P R E FA C E A N D I N T R O D U C T I O N Please carefully read this owner’s manual before using the power wheelchair. Improper use of the power wheelchair could result in, injury. This owner’s manual includes operating instructions for every aspect of the power wheelchair, including assembly instructions and how to deal with possible accidents.
2. SAFETY NOTICE 2.1 BEFORE DRIVING The user should become familiar with the usage and operation of this power wheelchair before driving. Therefore, please always keep the following safety notices in mind. ◆ Drive on the pavement, or pedestrian areas only. ◆ Do not drive your power wheelchair after consuming alcohol or when tired. ◆ Please be careful when driving your power wheelchair in low light. It has not been designed for use at night.
2. SAFETY NOTICE ■ About Mobile Phones and other electrical equipment ◆ Do not use a mobile phone or other wireless communication device while driving. ◆ Always switch off the power wheelchair and remove the ignition key before using a mobile phone. ◆ Do not charge the mobile phone or any other electrical device from the power wheelchair battery. ■ Automatic Power Shut Down In order to avoid accidental battery run down, your power wheelchair is equipped with an automatic power shut down.
2. SAFETY NOTICE Warning! ◆ Do not set in the freewheel mode when driving on a gradient. ◆ Always re-engage the anti-freewheel device before use. Fail to do so may result in injury. ◆ Always fasten the seat belt when operating the power wheelchair. ◆ To protect your safety, the power will automatically cut off and electromagnetic brake system will activate while driving down a steep gradient. This will limit the speed to a safe level. Turn the power on again to re-start your power wheelchair.
2. SAFETY NOTICE Attention When climbing an incline, do not zigzag or drive at an angle up the face of the of the incline. Always drive your power wheelchair straight up the incline. This greatly reduces the possibility of a tip or a fall. Always exercise extreme caution when negotiating an incline. Never travel up or down an incline that is or covered by snow or ice. ■ Inclines and uneven terrain When climbing an incline, try to keep your power wheelchair moving.
2. SAFETY NOTICE This section provides the user with basic information that describes the problems with electromagnetic interference (EMI), known sources of EMI, protective measure to either lessen the possibility or exposure or to minimize the degree of exposure, and suggested action should unexpected or erratic movement occur. Attention It is very important that you read this information regarding the possible effects of electromagnetic interference on your Sunfire Plus EC power wheelchair.
3. EMI Attention Other types of hand-held devices, such as cordless phones, laptop computers, AM/FM radios, TV sets, CD players, cassette and small appliances such as electric shavers and hair dryers are not , likely to cause EMI problems to your powered power wheelchair .
4. PA R T S I N T R O D U C T I O N PARTS DESCRIPTION 1. 2. 3. 4. 5. 6. 7. 8. 9. Controller Armrest Headrest Seatback Seat Seatback Release Lever Drive Wheel Caster Wheel Footrest 3 . 2. 4. 1. 6. 5. 7 . 9. 8 .
5. O P E R AT I O N JOYSTICK AND CONTROLLER Your Sunfire Plus EC is operated by a joystick and controller. The Sunfire Plus EC is currently available with one of two controller options: PG VR 2. 2 1 6 4 VR2 Series CONTROL FUNCTIONS 1. ON/OFF Button 2. Battery Gauge 7 5 3. Joystick 4. Maximum Speed / Profile Indicator 5. Speed / Profile Decrease Button 6.Horn Button 7.
5. O P E R AT I O N Attention We recommend that the first few times you operate your Sunfire Plus EC you turn the speed and respond adjustment knob to the slowest setting until you become familiar with you new power wheelchair. ◆ Speed / Profile Decrease Button This button decreases the maximum speed setting or , if the control system is programmed for drive profile operation, selects a lower drive profile. ◆ Horn Button Press either button to sound the horn.
5. ■ O P E R AT I O N JOYSTICK DEPTH ADJUSTMENT Your power wheelchair may be equipped with an adjustable joystick. This function enables you to move the joystick from the armrest to the desired position. Suggestion 1. You should recharge the batteries after each time the power wheelchair is used to ensure maximum range. The batteries should be charged at least once a week, even if the power wheelchair is not used. 2.
5. O P E R AT I O N Warning! When on a gradient, NEVER switch the power wheelchair to the freewheel mode. The electromagnetic brakes will not be applied and this may result in injury. HOW TO ADJUST THE SEAT ▇ To adjust the seatback angle ◆ Pull up the seatback release lever. ◆ Move the seatback down or up to the desired position . ◆ Release the seatback release lever. Seatback Release Lever ▇ To adjust the armrest width ◆ Loosen the knobs ◆ Slide the armrests in or out to the desired width .
5. O P E R AT I O N ▇ To adjust the armrests height ◆ Press the button. ◆ Move the armrest to the required position. Knob ▇ To adjust the headrest ◆ To raise headrest , lift it to the desired position. ◆ To lower headrest, push release tab towards the inside of the wheelchair and lower the headrest to the desired position. Adjust The Headrest ▇ To remove the seat 1. Turn the power OFF. 2. Make sure the Sunfire Plus EC is not in freewheel mode. 3.
5. O P E R AT I O N ▇ To change the seat height 1. Remove seat (See “To remove the Seat”) 2. Remove the shroud. 3. Disengage and remove the seat height adjustment bolt from the seat post. 4. Remove the height adjustment bolt from each of the three posts. 5. Raise or lower each post to the desired position. 6. Reinstall the seat height adjustment bolt through the seat post. 7. Reinstall the shroud. 8. Reinstall the seat.
5. O P E R AT I O N Warning! Do not use your Sunfire Plus EC Power Wheelchair while the drive motors are disengaged unless you are in the presence of an attendant! Do not disengage the drive motors when on an incline as the power wheelchair may roll down, causing injury! Suggestion If a level is difficult to move in either direction, gently rock the power wheelchair back and front; the level should then move to the desired position.
5.
6 . B AT T E RY C H A R G I N G A N D C A R E BATTERIES ◆ The Sunfire Plus EC Power Wheelchair uses two long- lasting, 12 volt, deep-cycle batteries. These batteries are sealed and maintenance free. Since they are sealed, there is no need to check the electrolyte (fluid) level. Deep-cycle batteries are designed to handle a longer and deeper discharge. Though they are similar in appearance to automotive batteries, they are not interchangeable.
6 . B AT T E RY C H A R G I N G A N D C A R E ▇ To charge the batteries using the off-board charger ◆ Position the power wheelchair next to a standard wall outlet. ◆ Be certain the controller power is turned off . ◆ Open the charging socket cap on the rear shroud .Then connect the charging cable into the charging socket. ◆ Plug the charging cable into the wall outlet. ◆ We also recommended that the batteries are not charged for more then 24 hours.
6 . B AT T E RY C H A R G I N G A N D C A R E ■ Cleaning the battery If the batteries are contaminated by water, battery acid, dust or other substances, they will discharge quickly. The batteries supplied with the power wheelchair are sealed and as such are maintenance free with no risk of battery leakage. Please follow the steps below to clean the battery. 1. Turn the Sunfire Plus EC power switch to OFF. 2. Remove the seat. 3. Remove the shroud and unplug the terminal of the taillight and signal lights. 4.
7. INSPECTION AND MAINTENANCE INSPECTION Initial adjustments should be made to suit personal body structure and preference. Be sure to, follow these checks and maintenance procedures. NO. Item 1 General(Mechanical Troubleshooting) ♦power wheelchair rolls straight (no excessive drag or pull to one side). Arms ♦Secure but easy to release; adjustment levers engage properly. ♦Adjustable height arms operate and lock securely. ♦Pivot point free of wear and looseness.
7. INSPECTION AND MAINTENANCE REGULAR CHECKING RECORD To make sure your power wheelchair is correctly serviced, take it to your dealer for regular maintenance checks. The initial inspection should be made after the first month’s use, thereafter every six months. Your dealer may charge a fee for this.
7. INSPECTION AND MAINTENANCE Attention When tread depth is below 0.5mm it can easily lead to power wheelchair slippage, making braking distances longer. Therefore replace the tyres as early as possible when they are found to have insufficient tread depth. Attention Before doing any maintenance, turn the power switch to OFF and remove the charger cords. Suggestions 1. Do not splash water onto the power wheelchair as this could cause the electronic system to malfunction. 2.
8 . T R O U B L E S H O O T I N G A N D S P E C I F I C AT I O N TROUBLE SHOOTING Symptom Probable cause Solution Limited driving distance ♦Batteries not fully charged. ♦Charge batteries overnight or ensure 10 hours of charge between uses. Make sure setting on charger is correct. Batteries not charging. ♦Batteries weak won’t hold charge. ♦Replace batteries ♦Charger not working ♦Replace charger. ♦Battery connections loose. ♦Check all connections. Secure connections. ♦No current at wall outlet.
8 . T R O U B L E S H O O T I N G A N D S P E C I F I C AT I O N Wheelchair does not ♦Poor battery terminal connection. ♦Clean terminals. ♦Electrical malfunction. ♦Contact dealer respond to commands. Power indicator off even after recharging. SPECIFICTIONS MODEL Sunfire Plus EC ITEM Dimension (L×W×H ) 37.5 “ x 23.5” x 43.5” Weight, with batteries Without batteries 211 lbs. 158 lbs. Battery 12V U1×2 Motor 270W × 2 Charger DC24V 4A OFF-BOARD Front wheels 8” × 2.
8 . T R O U B L E S H O O T I N G A N D S P E C I F I C AT I O N SELF-HELP GUIDE If a system trip occurs, you can find out what has happened by counting the number of bars on the battery gauge that are flashing. Overleaf is a list of self-help actions. Try to use this list before you contact your service agent. Go to the number in the list that matches the number Of flashing bars and follow the instructions. If the problem persists after you made the checks described above contact your service agent.
9. WARRANTY Your Drive brand product is warranted to be free of defects in materials and workmanship as follows: Chair/Scooter frame: Lifetime Electronic Controller and drive train components: 1 year Batteries: 6 months from time of installation This device was built to exacting standards and carefully inspected prior to shipment.
9. WARRANTY Warranty Registration Please type or print. Serial # _______________________________________ Owner Name Date Purchased ____/____/____ ____________________________________________________________ Address _________________________________________________________________ City ____________________________________ State ________ Zip ________ Additional Required Owner Information Please indicate your understanding of your scooter by completing the following information.
9. WARRANTY VIN (POWERCHAIR INDIFICATION NUMBER) To ensure the correct after sales, service and warranty service support, please write down the power chair identification number found on the rear right-hand side of the frame.
99 Seaview Boulevard Port Washington, NY 11050 516-998-4600 877-224-0946 www.drivemedical.
31
