Owner`s manual

5 . O P E R AT I O N

▇ To change the seat height

1. Remove seat (See “To remove the Seat”)

2. Remove the shroud.

3. Disengage and remove the seat height adjustment bolt from the seat post.

4. Remove the height adjustment bolt from each of the three posts.

5. Raise or lower each post to the desired position.

6. Reinstall the seat height adjustment bolt through the seat post.

7. Reinstall the shroud.

8. Reinstall the seat.

HOW TO ADJUST THE FOOTREST

▇ To adjust the footrest angle

You can adjust the angle of the footrest with a hex wrench.

◆ Turn the setscrew clockwise to raise the front of the footrest.

◆ Turn the setscrew clockwise to lower the front of the footrest.

▇ To adjust the footrest height

◆ Remove the quick release pin.

◆ Adjust footboard to one(1) of three (3) mounting positions.

◆ Install the quick release pin. Make sure the detent ball is engaged with the outer edge of the tube.

HOW TO SET TO FREEWHEEL MODE

For your convenience, the Sunfire Plus EC Plus is equipped with a freewheel level. This level allows

you to disengage the drive motors and maneuver the wheelchair manually.

▇ To engage the drive and take power wheelchair out of freewheel

◆ Pull the freewheel lever to ”DRIVE” position (left and right).

◆ Activation of the joystick automatically releases the brake so the powered Sunfire Plus EC

can be driven.

▇ To disengage the drive and place power wheelchair in freewheel

◆ Push the freewheel lever to “NEUTRAL” position (left and right).

Setscrew

Luck Nut

Bolt