SDS

www.trivalent.com Powered by
00000680 SAFETY DATA SHEET Page 2
CODE: A6-000409-USAPRODUCT: Lubco Dry Shine Foaming Glass Cleaner- 517g (USA)
SECTION 04: FIRST AID MEASURES
Eye Contact................................................... Check for and remove contact lenses. Immediately flush eyes with water for a minimum of
15 minutes keeping eyelids open. Consult a doctor if any irritation occurs.
Ingestion........................................................ Ingestion is unlikely to occur. If swallowed do not induce vomiting because of risk of
aspiration into the lungs. If aspiration is suspected obtain immediate medical attention.
Most important symptoms/effects, acute and Symptoms may include stinging, tearing, redness, swelling, and blurred vision. Direct
delayed contact with eyes may cause temporary irritation. Vapors have a narcotic effect and may
cause headache, fatigue, dizziness and nausea. May cause redness and pain.
Indication of immediate medical attention and Provide general supportive measures and treat symptomatically. In case of shortness of
special treatment needed breath give oxygen. Keep victim warm. Keep victim under observation. Symptoms may be
delayed.
SECTION 05: FIRE FIGHTING MEASURES
Suitable Extinguishing Media........................ Dry chemical powder. Carbon dioxide. Foam, water spray or fog.
Unsuitable Extinguishing Media.................... Do not use water jet as an extinguisher, as this will spread the fire.
Specific Hazards Arising from the Chemical. In case of fire, the following can be released: Carbon Oxides (CO, CO2), Other unidentified
Organic Compounds.
Special Protective Equipment and ............... Firefighters must use standard protective equipment including flame retardant coat, helmet
Precautions for Firefighters with water to prevent vapor pressure build up. For massive fire in cargo area, use
unmanned hose holder or monitor nozzles, if possible. If not, withdraw and let fire burn out.
General Fire Hazards.................................... N/A.
SECTION 06: ACCIDENTAL RELEASE MEASURES
Personal Precautions, Protective Equipment No action shall be taken involving any personal risk or without suitable training. Evacuate
and Emergency Procedures surrounding areas. Keep unnecessary and unprotected personnel from entering. Avoid
walking through spilled material. Avoid breathing vapor or mist. Provide adequate
ventilation. Wear appropriate respirator when ventilation is inadequate. Put on appropriate
personal protective equipment (see Section 08).
Methods and Materials for Containment and Contain spillage, and then collect with non-combustible absorbent material, (e.g. sand,
Cleaning Up earth, diatomaceous earth, vermiculite) and place in container for disposal according to
local/national regulations (see section 13). Eliminate all ignition sources (no smoking,
flares, sparks, or flames in immediate area). Keep combustibles (wood, paper, oil, etc.)
away from spilled material.
Environmental Precautions........................... Keep out of drains, sewers, ditches, and waterways. Minimize use of water to prevent
environmental contamination.
SECTION 07: HANDLING AND STORAGE
Precautions for Safe Handling....................... Pressurized container: Do not pierce or burn, even after use. Do not use if spray button is
missing or defective. Do not spray on a naked flame or any other incandescent material.
Do not smoke while using or until sprayed surface is thoroughly dry. Do not pressurize, cut,
weld, braze, solder, drill, grind, or expose empty containers to heat, sparks or open flames.
Avoid breathing vapour of this product. Avoid contact with skin and eyes. Avoid prolonged
exposure. Use in well-ventilated areas.
Conditions for Safe Storage including any ... Store locked up. Pressurized container. Protect from sunlight and do not expose to
Incompatibilities temperatures exceeding 50°C (122°F). Do not puncture, incinerate or crush. Do not handle
or store near an open flame, heat or other sources of ignition. Store away from
incompatible materials (see Section 10).
SECTION 08: EXPOSURE CONTROLS / PERSONAL PROTECTION
ACGIH TLV OSHA PEL NIOSH
INGREDIENTS TWA STEL PEL STEL REL
Isopropyl Alcohol 400 ppm (980 mg/m3) 500 ppm (1,225 400 ppm (980 500 ppm (1,225 400 ppm (980
mg/m3) mg/m3) mg/m3) mg/m3)
Isobutane Not available 1,000 ppm Not available Not available Not available
2-Butoxyethanol 20 ppm Not available 50 ppm Not available Not available
Surfactants Not available Not available Not available Not available Not available
Appropriate Engineering Controls................. Local exhaust ventilation required to maintain the point of use below the Threshold Limit
Value if unprotected personnel are involved.
Individual Protection Measures:
Eye/Face Protection...................................... Chemical splash goggles are recommended.
Skin Protection.............................................. Chemical resistant gloves are recommended. Avoid contact with the skin. Wear
appropriate chemical resistant clothing.
Respiratory Protection................................... Use dust and mist respirator.