SDS

www.trivalent.com Powered by
00000697 SAFETY DATA SHEET Page 2
CODE: A6-000410-USAPRODUCT: Lubco Dry Shine Foaming Tire Shine - 500 g (18 oz.)
SECTION 04: FIRST-AID MEASURES
Skin Contact.............................................. Immediately flush the contaminated skin with soap and water. If this chemical penetrates
clothing, immediately remove the clothing and flush the skin with water. If irritation persists
after washing, get medical attention . Remove contaminated clothing. Launder clothing
before reuse. If irritation occurs consult with your doctor.
Ingestion.................................................... Not likely to be ingested. If occurs, do not give anything by mouth to an unconscious
person. Do not induce vomiting, get medical attention. Obtain medical advice.
Most important symptoms/effects, acute .. Direct eye contact may cause temporary eye irritation.
and delayed
Indication of immediate medical attention Provide general supportive measures and treat symptomatically. In case of shortness of
and special treatment needed breath give oxygen. Keep victim warm. Keep victim under observation. Symptoms may be
delayed.
SECTION 05: FIRE-FIGHTING MEASURES
Suitable Extinguishing Media.................... Dry chemical powder. Carbon dioxide. Foam, water spray or fog.
Unsuitable Extinguishing Media................ Do not use water jet as an extinguisher, as this will spread the fire.
Specific Hazards Arising from the Chemical Contents under pressure. Pressurized container may explode when exposed to heat or
flame.
Special Protective Equipment and ........... Firefighters must use standard protective equipment including flame retardant coat, helmet
Precautions for Firefighters with water to prevent vapor pressure build up. Collect contaminated fire extinguishing water
separately. This must not be discharged into drains. Remove undamaged containers from
immediate hazard area if it is safe to do.
SECTION 06: ACCIDENTAL RELEASE MEASURES
Personal Precautions, Protective ............. Ensure adequate ventilation; avoid formation of dust. Wear protective equipment and keep
Equipment and Emergency Procedures unprotected persons away. Use respiratory protection against the effects of dust.
Methods and Materials for Containment .. Contain spillage, and then collect with non-combustible absorbent material, (e.g. sand,
and Cleaning Up earth, diatomaceous earth, vermiculite) and place in container for disposal according to
local/national regulations (see section 13). Eliminate all ignition sources (no smoking,
flares, sparks, or flames in immediate area). Keep combustibles (wood, paper, oil, etc.)
away from spilled material.
Environmental Precautions....................... Keep out of drains, sewers, ditches, and waterways. Minimize use of water to prevent
environmental contamination.
SECTION 07: HANDLING AND STORAGE
Precautions for Safe Handling................... Wash thoroughly after handling . Pressurized container: Do not pierce or burn, even after
use. Do not use if spray button is missing or defective. Do not spray on a naked flame or
any other incandescent material. Avoid contact with eyes. Avoid breathing vapours or
spray mists of this product. Use with adequate ventilation. Keep away from heat, sparks,
and open flames.
Conditions for Safe Storage including any Store in a cool, dry, well-ventilated area away from incompatible substances. Do not store
Incompatibilities in direct sunlight. Do not handle or store near an open flame, heat or other sources of
ignition. Store away from incompatible materials (see Section 10).
SECTION 08: EXPOSURE CONTROLS / PERSONAL PROTECTION
ACGIH TLV OSHA PEL NIOSH
INGREDIENTS TWA STEL PEL STEL REL
Silicones Not established Not established Not established Not established Not established
Isobutane Not available 1,000 ppm Not available Not available Not available
Propane Not available Not available 1,000 ppm Not available Not available
Appropriate Engineering Controls............. Local exhaust ventilation required to maintain the point of use below the Threshold Limit
Value if unprotected personnel are involved. Ground all equipment and cylinders before
use.
Individual Protection Measures:
Eye/Face Protection.................................. Prevent eye contact, wear safety glasses in the event that eye contact is possible.
Skin Protection.......................................... Normally, no hand protection is required; however, prolonged or repeated contact with skin
use chemical resistant gloves conforming to appropriate regulations. Observe the
instructions regarding permeability and breakthrough time that are provided by the supplier
of the gloves. Use rubber or latex gloves when there is a potential for prolonged or
excessive skin contact.
Respiratory Protection............................... Use approved NIOSH respirators for emergencies. Typical use of this product under
normal conditions does not require the use of respiratory protection. If airborne
concentrations are above the applicable exposure limits (listed below), use NIOSH
approved respiratory protection .