SDS

8.2 Exposure controls
Appropriate engineering controls
General ventilation.
Individual protection measures (personal protective equipment)
Eye/face protection
Wear eye/face protection.
Skin protection
- Hand protection
Wear suitable gloves. Chemical protection gloves are suitable, which are tested according to EN 374. Check leak-
tightness/impermeability prior to use. In the case of wanting to use the gloves again, clean them before taking off
and air them well. For special purposes, it is recommended to check the resistance to chemicals of the protective
gloves mentioned above together with the supplier of these gloves.
- Other protection measures
Take recovery periods for skin regeneration. Preventive skin protection (barrier creams/ointments) is recommended.
Wash hands thoroughly after handling.
Respiratory protection
In case of inadequate ventilation wear respiratory protection.
Environmental exposure controls
Use appropriate container to avoid environmental contamination. Keep away from drains, surface and ground water.
SECTION 9: Physical and chemical properties
9.1 Information on basic physical and chemical properties
Appearance
Physical state liquid
Color various
Odor like ammonia
Other safety parameters
pH (value) 9.4 – 9.6 (water: 1
mg
/
cm³
, 25 °C)
Melting point/freezing point not determined
Initial boiling point and boiling range 184 °C at 100.3 kPa
Flash point not determined
Evaporation rate not determined
Flammability (solid, gas) not relevant, (fluid)
Explosive limits
Safety Data Sheet
acc. to 29 CFR 1910.1200 App D
DRYLOK® Original Basement & Masonry Waterproofer
Version number: REV 1.0 Date of compilation: 2020-07-10
United States: en
Page: 7 / 15