Installation Guide
DD
DD
EE
7
□
□
□
□
□
□
Trimming excess xture wire
6
Unthread the canopy lock ring.
Slide canopy lock ring and ceiling canopy (EE) down the quick
link (DD).
Push all slack xture wire through canopy chain loop and into
the outlet box.
Trim excess xture wire leaving a minimum of 6 inches
hanging out of the outlet box.
Separate the smooth side and ribbed side of the supply wire to
about 3 inches from the end.
Using wire strippers, strip each wire ½ inch from the end.
Installation (continued)
Supply wire
and ground wire
Canopy lock ring
7
Making the electrical connections
□
□
* Use wire connectors (CC) to connect the wires.
Ground wire:
1. Wrap supply ground wire around green ground screw on
crossbar, no less than 2 in. from the end of the wire. Tighten
ground screw.
2. Connect xture ground wire to supply ground wire with
wire connector (CC).
Supply wire:
1. Connect the house white wire to the xture supply wire
(ribbed sided) from xture identied with the label “N”.
2. Connect the house black (or red) wire to the xture supply
wire (smooth side) from xture identied with the label “L”.
3. Wrap each connection with approved electrical tape and
carefully stuff all of the connected wires into the outlet box.
CC
Ground wire
from supply
Ground wire from xture identied
with the label “G”
Green ground screw
Black (or red)
wire from supply
Ribbed side of wire from
xture identied with the
label “N”
Smooth side of wire from
xture identied with the label “L”
White wire from supply