User`s manual

* * Home Central Audio System
10
4. Manual Operation of Tuner
Press the “TUNER” key to access the tuner control interface (as shown in Fig. 4-1), where the band,
station and mono/stereo can be set.
4.1 Band selection
Press the “BAND” key to switch between AM and FM bands. Also, this can be performed by a line
or IR remote controller. The frequency range of AM band is 522–1620 kHz, and 87.00–108.00 MHz
for FM band.
4.2 Tuning
Press the “ ” or “ ” key on the panel select a station stored. Turn the digital wheel for tuning
by frequency. Turn the wheel clockwise to tune to a higher frequency, or turn it counterclockwise to
tune to a lower frequency. In case that a station is tuned in to, signal bar indicator as shown in Fig.
4-1 is shown. More bars will be shown if the signal is strong.
4.3 Storage of station
In case that a station is tuned in to, press the “MEMO” key in combination with the “ ” or
“ ” key to store the station as the storage number successively or randomly. Up to 40 station
numbers are available. To store a station, press the “MEMO” key once, and the storage number
following the “MEMO” option on the display will flash. Press the “ ” or “ ” key to adjust the
number, and then press the “MEMO” key again to store the station.
4.4 Mute mode
Press the “ ” key on the panel, and the “ ” icon will turn into the “ ” icon (as shown in
Fig.4-2) indicating that the console is in mute mode. The preset timer is executed at the scheduled
time. Press the “ ” key again to exit from the mute mode.
4.5 Calling a station
Ø A stored station can be called at the scheduled time. For details, refer to timer setting.
Mode
MP3 player
03
\
0 1
A thousand dreams of you
(Fig. 3-1)
All
00
：
00
00
：
00
(Fig. 4-1)
Band FM
100.45MHz
Signal
Mono
AM/FM tuner
Memo 40
(Fig. 4-2)
Band FM
100.45MHz
Signal
Mono
AM/FM tuner
Memo 40
Tuner mute
mode