Owner`s manual
XDVDN8290N OPERATION
11
Control Functions - Monitor Closed
This button performs different functions depending on the current mode.
A detailed description of the
OUT
button can be found in each individual section.
This button performs different functions depending on the current mode.
A detailed description of the
IN
button can be found in each individual section.
Press to center the map on the current vehicle position. Also cancels panning
and destination setting. This button only works during navigation mode.
Press to display DVD disc information in DVD mode. Holding this button for 3
seconds brings up the Brightness setting, which can be controlled by the rotary
encoder or by pressing the
OUT
IN
buttons on the main remote control.
Note: The Brightness can not be adjusted in Bluetooth mode.
Press
momentarily to toggle between fully open and the current angle.
Hold
for more than 1 second to adjust the view angle up and down and
release to keep desired viewing angle.
If you experience abnormal operation or, your unit is inoperable, press the
RESET button located on the front bottom-right corner of the unit. After a
system reset, the unit resets the main processor (but not the default settings).
Notes: Use the tip of a pen to access the reset button. To restore the factory
default settings, refer to page 21.
Monitor Notes:
• The angle can also be manually selected via the screen setup menu.
• The color of the LCD monitor varies between viewing angles. Select the angle
with the most optimum view for your location.
• The last position of the monitor can be saved in memory. When “TFT Auto
Open” is selected in the General Setup Menu, the monitor will return to its last
position automatically the next time the unit is turned on.
• Due to its highly technological design, the XDVDN8290N faceplate is NOT
removable. Do not attempt to remove the faceplate.
• Upon installation, do not attempt to move the monitor by hand. Use the
button on the front panel only or the OPEN button on the remote control.
• The unit will stop if it encounters any obstacles during the open/close
sequence. If this occurs, remove the obstacle and press
or OPEN again to
resume the monitor open/close sequence.
Up Arrow/OUT
Down Arrow/IN
POS
Info/Picture
Monitor Open/Close
Angle Position
Reset
Caution