Instruction manual

19
NO COFFEE
FLOWING
FROM THE
BREWHEAD.
IMPORTANT:
If you can hear the pump
operating but no water
comes out, SWITCH
OFF THE MACHINE
IMMEDIATELY, leave for
30 minutes to allow any
pressure built up in the
machine to dissipate to
avoid scalding.
Dispense water through the
brewhead (4). Ensure
NNOO
coffee is in the filter. If you see
water go to fig 3.
IIff nnoott,, ttuurrnn
ooffff iimmmmeeddiiaatteellyy aanndd sseeee ffiigg 44..
Ensure water tank (11) is
correctly seated in position.
You will see air bubbles at
the connection when
correctly located.
Ensure you are not tamping
too hard, the water will not
be able to flow through the
ground coffee.
Your brewhead or filter may
be blocked with fine coffee
grounds or limescale.
Remove showerhead and
clean the brewhead.
1
4
2
3
CHECK TANK
CHECK FOR BLOCKAGES
DISPENSE TEST
CHECK THE TAMP
Lightly
To unblock the filter, use a
small pin and gently push
through the hole on the
underside to unblock.
Once re-assembled, descale
as per page 17.
IMPORTANT: FAILURE TO DESCALE AND CLEAN YOUR MACHINE
WILL INVALIDATE YOUR GUARANTEE.
18
MY COFFEE
IS NOT HOT
ENOUGH.
IMPORTANT:
It is imperative to pre-heat
the thermobloc, filter holder
and cup to the correct
operating temperature
before the first use.
Thereafter subsequent
cups must be pre-warmed
before
EEAACCHH
coffee.
Set the power switch (2) to
‘ON’.The thermobloc water
heater system is now heating
to the correct temperature.
Dispense a mug full of
water (min 240ml) through
the machine. Ensure
NNOO
coffee is in the filter
holder (5).
The temperature indicator
(12) will go out once the
thermobloc is at the correct
operating temperature.
If you like your coffee extra
hot, the serving cup or mug
must be warmed through
before EACH coffee.
Discard the water from the
pre-warmed cup and dry.
Add your ground coffee or
ESE pod and your machine is
ready to go...
1
2
5
3
4
40
SEC
TURN ON
WAIT 40 SECONDS
READY
PRE-HEAT
WARM CUP
CHOC
PODS
MILK
TROUBLESHOOTING
dcm1 ib_2009.2.25.qxp 27/02/2009 14:16 Page 18