Instruction manual

9
USING ESE COFFEE PODS
ESE (Easy Serving Espresso) pods are individually wrapped and pre-tamped
ensuring the perfect espresso every time. Look for the ESE logo on compatible coffee pods.
Coffee pods are available
directly from the Dualit
website or call Dualit sales
on 01293 652 500
(UK delivery only).
Each pod is individually
wrapped so you only use
what you need. Place one
fresh coffee pod into the
ESE filter.
Select the ESE pod filter (16)
and snap into the filter
holder (5).
Make sure there is no gap
between the pod and filter
edge, or water will flow
round the pod and your
espresso will be diluted.
Make sure all the paper is
tucked inside the filter
before attaching the filter
holder to the brewhead (4).
1
2
5
3
4
PURCHASE PODS
THE ESE FILTER
TUCK TAB
INSERT POD
CHECK SEAL
Use the tab to remove the
pod once the coffee has
been made.
6
REMOVE WITH TAB
8
Set the power switch (2) to
‘ON’.The thermobloc water
heater system is now heating
to the correct temperature.
Dispense a mug full of
water (min 240ml) through
the machine. Ensure
NNOO
coffee is in the filter
holder (5).
The temperature neon will
go out once the thermobloc
is at the correct operating
temperature.
If you like your coffee extra
hot, the serving cup or mug
must be warmed through
before
EEAACCHH
coffee.
Discard the water from the
pre-warmed cup or mug, dry
and place back under the
filter holder and your
machine is ready to go...
2
3
6
4
5
PRIMING - BEFORE EACH COFFEE
The brewhead (4), filter holder (5) and cup must be the correct operating temperature
before the first use.Thereafter subsequent cups must be pre-warmed before
EEAACCHH
coffee.
TURN ON
WAIT 40 SECONDS
READY
PRE-HEAT FILTER
HOLDER
WARM CUP
Fill the water tank (11) with
water; do not go above the
‘MAX’ mark. Filtered water
will reduce the build up of
limescale inside the machine.
1
FILL WATER TANK
40
SEC
CHOC
PODS
MILK
dcm1 ib_2009.2.25.qxp 27/02/2009 14:09 Page 8