Instructions / Assembly

ManualsBrandsDuPont ManualsKitchen3 Stage QuickTwist Purifier Undersink Water Filtration System

WFQT39000 Series

V4.0

STEP 3

Mount the System Head

1 Choose an easy-to-access area under the sink to mount the Filter System.

NOTE: To allow adequate space for filter changes, allow a minimum clearance of 4-6" below the QuickTwist

™

Filters. The Filter System

must be mounted in a vertical position.

NOTE: Mount the Filter System to a solid cabinet wall or wall. If a solid surface is not available, use hollow-wall anchor bolts or toggle

bolts (not included) to secure to the wall.

2 Remove cartridges from system head by turning from right to left.

3 Remove the cap from the top of the System Head A. Using the Built-in Bracket on the back of the System Head, mark the holes for

the Mounting Screws

C on the wall surface.

4 Using a 1/8" drill bit, drill two pilot holes for the Mounting Screws. Insert Mounting Screws into the wall with a Phillips screwdriver,

leaving approximately 3/8" of each Mounting Screw exposed.

5 Hang the System Head on the eyes of the bracket and replace the System Head cap.

STEP 4

Install 1/4" Plastic Tubing for Water Supply Line from

Kitchen Faucet Adapter to System Head Inlet

1 Determine the length of 1/4" Plastic Tubing L that will be necessary to connect the System Head Inlet to the Kitchen Faucet

Adapter

H. Make sure to allow enough Plastic Tubing to prevent kinking in the line.

2 Cut the 1/4" Plastic Tubing squarely on both ends with a utility knife, making sure not to crimp the Plastic Tubing during cutting.

3 Wet one end of the 1/4" Plastic Tubing with water and push it into the Kitchen Faucet Adapter approximately 5/8" until it stops.

NOTE: Do not bend or crimp 1/4" Plastic Tubing when inserting.

4 Wet the other end of the 1/4" Plastic Tubing with water and push it into the System Head Inlet approximately 5/8" until it stops.

NOTE: The 1/4" Plastic T

ubing does not need to be disconnected for general r

outine maintenance and filter replacement. However,

Plastic Tubing may be easily disconnected if necessary. Simply turn off the water supply to the Filter System and press in the grey collar

ound the fitting while pulling the Plastic T

ubing out with the other hand.

Be sure that all electrical appliances and outlets are turned off at the

circuit breaker before working in cabinet area.

WARNING

Please wear safety glasses to protect

eyes when drilling.

CAUTION

WFQT270005

4-6"

INLET

UTLET

INLET

OUTLET

HOT WATER

1/4" PLASTIC

TUBING

COLD WATER

5/8"