Installation Guide

2
500 lbs
500 lbs
300 lbs
265 lbs
TO REDUCE THE RISK OF INJURY, PLEASE READ AND
UNDERSTAND ALL INSTRUCTIONS BEFORE USING
THIS PRODUCT. FAILURE TO FOLLOW ALL INSTRUCTIONS
BELOW MAY RESULT IN SERIOUS PERSONAL INJURY.
SAVE THIS MANUAL FOR FUTURE REFERENCE.
ELECTRICAL SHOCK HAZARD: This product has an electrical
socket on one side which requires plug for electric supply.
Incorrect connection may cause electrical shock, which may
result in injury or death.
ELECTRICAL SHOCK RISK: Do not connect to electricity if
there is a water, including in humidweather, or placed near
awaterpipe.
POWER REQUIREMENTS: 120V AC, 15 amp Max, 12 AWG
Cord Only.
When not use this product, do not store this product in a
humid place to avoid damaging product.
When using this product in the scaffold mode, keep your feet
firmly planted in the center of the scaffold. Do not step on the
four corners of the product surface as this may cause the
product to tip over and result in personal injury.
When using this product in the scaffold or workbench modes,
place objects in the center of the product’s surface. Placing
objects on the corners may cause the product to tip over. Only
workbench and scaffold mode can hang the basket.
When using this product in the creeper or cart modes, do
not step or stand on this product, as this may cause personal
injury.
When extending or retracting the legs, do not use excessive
force as this may damage the product.
Before using this products, make sure that the legs are firmly
locked in position and latches are closed tightly over the top
panel.
Please follow the instruction, and do not use this products for
any other purpose.
When using this product with power tools, referring to the
manufacturer’s instructions for properly using electric tools.
Always wear safety goggles.
Do not exceed the following weight capacities:
Workbench
Scaffold
Cart
Creeper
Electrical sockets are placed on one side of the product.
Connect an external power source to the socket using a
2-pronged and 2 USB port extension cord. You can connect
up to 2 power tools to the power strip simultaneously.
You can write and draw on work surface and store your
working accessory in 2 trays under the panel.
Place bucket into the circle of the left side of the scaffold
surface. Stand in the center of the scaffold surface. Do not
stand or step on the location marked with X’s in the figure to
the right as this may cause the product to tip over and result
in personal injury.
CAUTION: Work scaffold mode only has 500lbs weight
capacity. DON’T use scaffold with legs fully extended. This
will cause serious injury.
CART MODE
WEIGHT CAPACITIES
SCAFFOLD MODE
WORKBENCH MODE
Put object in the center of the work surface. Be aware of
the object fall off.
CAUTION: Before using cart mode, please remove the basket.
DON’T exceed over 300lbs weight capacity. Do not step or
stand on the work surface in cart mode.
GENERAL SAFETY INSTRUCTIONS
IMPORTANT SAFETY INSTRUCTIONS
2 trays
under the
panel
If needed,tool
basket can hang
on the hole of
long side.
2 power
tools 2
USB port