Installation Guide

CREEPER MODE

Use this mode to perform job in low spaces. Also put the

product into this mode when storing or moving. A carrying

handle is provided.

CAUTION: Before using creeper mode, please remove the

basket. Do not step or stand on the work surface in creeper

mode.

CREEPER MODE TO WORKBENCH MODE

a. Turn the product over, release the lock from the narrower

set of legs

b. Turn the narrower legs outward.

c. Then open the wider set of legs and turn the wider legs

outward.

d. Push the Y-type brace until it locks.

e. Fold the side-step into the horizontal position on the side.

e. Lay the product down on the floor, press each pin on legs and

pull legs out until the pin clicks.

CAUTION: Make sure the pin on each leg clicks out before

using the products. Failure to do this may lead to the legs

retracting while using.

a. Lay the product down on the floor, press the pin on each leg

and push each leg in until the pin clicks into place on the

upper holes.

b. Stand the product up and open the two latches on the two

longer sides.

WORKBENCH MODE TO SCAFFOLD MODE

Press the pin and push the leg in

Press the pin

Pull the leg down

Push the pin into the hole

NOTE: You must open the narrower set oflegs first, then the

wider set of legs. Otherwise the legs can not open.