Installation Guide

SCAFFOLD MODE TO CREEPER MODE

a. Turn the product over and flip down the step on the side.

d. Turn the product over so the wheels are on the floor, open the

latches , remove the panel and turn it over to the smooth

surface, then fasten the latches.

Flip down the step

on the side.

b. Press the wider Y-type brace and push the wider legs

inward until they are locked in place.

c. Repeat this procedure for the narrower Y-type brace and

narrower legs.

CREEPER MODE TO CART MODE

a. Open the two latches, pull out the panel and pull up the

handle.

b. Turn over the panel to anti-slip work surface. Slip the panel

into the corner protectors fasten the latches.

c. Remove the panel, turn it over so that the anti-slip work

surface is face up, and place it back onto the scaffold.

Fasten the two latches.

NOTE: You must close the wider set of legs first, then the

narrower set of legs. Otherwise the legs will not close

properly.

With draw the

legs and press

the locking pin

to secure.