user manual

-10-

V. INSTALLING THE FUEL CANISTER

NOTE: Use only 1 L duraame illuma-fuel bio-ethanol fuel canisters with this appliance. The

canisters are NOT rellable.

1. Remove the log that covers the door of the canister compartment. Set the log in a safe place

where it will not be damaged. (see Figure 11). Do not touch the log in any area other than

the one shown when ﬂames are present or the appliance is still hot.

2. Open the door of the fuel canister compartment using the hole in the door. (see Figure 12).

3. Remove the screw cap from a canister of illuma-fuel to expose the foil seal covering the

opening. DO NOT remove the foil seal.

4. Invert the canister and position it so that the left end of the canister ts under the bracket

at the end of the fuel tray (see Figure 13). Lower the canister so that neck is aligned with

the piercer hole in the tray at the bottom of the fuel compartment. Push down rmly on the

canister until the piercer punctures the foil seal and the canister is seated rmly on the tray.

To assist the ow of fuel from the canister, wiggle it back and forth slightly on the piercer. You

Figure12

Opening Compartment door

Figure14

Closing Compartment door

Figure 11

Removing Log #1

Figure13

Tank Installation and Removal