user manual
-11-
might hear a soft gurgling noise as the fuel from the canister begins to ll the burner—this is
normal. Make sure the left side is tipped down during installation.
5. After the canister has been installed, close the door of the fuel compartment using the hook on
either side of the door, and replace the log that was removed in step 1. (see Figure 14).
The appliance is now ready for use. Make sure you use the hook on either side of the door
to close the door when the appliance is hot. The hooks are cooler than other parts of
the door.
VI. OPERATION
WARNING: If you do not follow these instructions exactly, a fire may result, causing property
damage, personal injury or loss of life.
NOTE: During initial operation of the new appliance, the logs may emit a slight odor. This is
normal, and the odor will dissipate after a few hours.
1. Before lighting the appliance, check to see that the burners are free of any obstructions. Also
make certain that there is no water in the burners. If you nd water, you must empty it out (see
Section IX).
2. If you have just installed a canister of illuma-fuel, you may need to wait a minute or so to
allow the fuel to drain into the burner. When you can see fuel in all three burner cups, light
a long match or a long butane lighter and hold the ame down in each cup until it ignites.
(WARNING: Do not use a short match to light the burner, as this could result in burns.)
Initially, the ames might have a bluish hue. This will quickly change to a yellow ame as the
fuel heats up.
3. To extinguish the ames, grasp the end of the snuer tool that is provided with this appliance.
Lower the rounded end of the snuer down into each burner cylinder slowly and seat it in the
hole of the burner. The hole must be completely covered to extinguish the ames. Note that
this appliance can be relit at any time—immediately, if desired.
4. Any unused fuel that remains in the burners/tray/canister after the unit is extinguished will
eventually evaporate.
VII. REFUELING
This appliance is designed so that a canister of illuma-fuel will provide a continuous supply of
fuel to the burner for about an hour and forty minutes on its maximum setting*. To allow for
uninterrupted burning beyond this time, the burner has been designed so that about ten minutes
before the fuel is completely exhausted, the ames in the two burner cylinders nearest to the fuel
compartment will go out, and only the single remaining burner cylinder will be burning. At this
point, you can replace the empty canister with a full one. This can be done while the appliance is
burning - there is no need to extinguish all the ames. The two burners without ames may need
to be relit after the canister is replaced.
To replace the canister: