user manual

-14-
SOLUTION
• DO NOT light the burner. Extinguish any open
ame near the spill. Wipe up the spill, and wait
several minutes for the residue to evaporate. If
you see no additional fuel on the ground, you
may light the burner. If you see additional fuel
on the ground, you might have a leak. DO NOT
use this appliance if it leaks fuel.
• The appliance might be out of level. Check
to make sure the appliance is level, and shim
under the table legs, if necessary. Shim only
with metal washers or other non-ammable
objects.
• A small piece of foil that covers the opening of
the illuma-fuel canister might be obstructing the
piercer tube. Remove the log above the fuel
compartment, and open the fuel compartment
door. Gently wiggle the fuel canister tray to
enlarge the opening in the foil. DO NOT lift the
illuma-fuel canister from the fuel tray, as this
could cause a fuel spill.
• The tubes connecting the burner cups to
the fuel reservoir and to each other may be
clogged. (This is almost certainly the case if
only one of the burner cups does not contain
fuel.) Starting at the tube opening in the
bottom of the burner cup, run a thin, exible
wire the length of the tube to remove the
obstruction.
• The Illuma-Fuel might be contaminated with
water. See Section IX. EMPTYING WATER
FROM THE BURNERS, above. (NOTE: You
should always check for water in the burner
cups and empty any water you might nd
BEFORE installing an illuma-fuel canister. If
you nd that there is water in the burners after
you have installed a canister, you must remove
the canister before emptying the water. This
will result in a small fuel spill. DO NOT light
the burner. Extinguish any open ame near
the spill. Wipe up the spill, and wait several
minutes for the residue to evaporate.)
• Conditions might be too windy to use the
appliance. DO NOT attempt to block the wind
with combustible materials, as this could result
in a re.
XI. TROUBLESHOOTING
Use the following guide to solve any problems you might encounter in operating this appliance.
PROBLEM
1. You see fuel on the ground near the
appliance.
2. You do not see fuel in the burner cups prior
to lighting the appliance.
3. You see fuel in the burner cups, but the
appliance will not light.
4. The burners light, but will not stay lit.