Use and Care Manual
The heater is designed and approved for use as a construction heater under ANSI Z83.7 CSA 2.14.
It is hard to anticipate every use which may be made of this heater.
CHECK WITH YOUR LOCAL
FIRE SAFETY AUTHORITY IF YOU HAVE QUESTIONS ABOUT APPLICATIONS.
PROPANE TANK TOP CONSTRUCTION HEATERS
This is a direct-red tank top construction heater for either indoor construction or outdoor use. Its intended
use is primarily the temporary heating of buildings or structures under construction, alteration or repair. All the
products of combustion generated by the heater are forced through the heater and released into the area being
heated. This heater operates at approximately 98%+ combustion efciency but still produces a small amount
of carbon monoxide. Humans can tolerate small amounts of carbon monoxide for short periods. Carbon
monoxide can build up in a heated space and failure to provide adequate ventilation could result in poisoning
or death.
Other standards govern the use of fuel gases and heat producing products in specic applications.
Your local authority can advise you about these.
IMPORTANT: READ THIS USER’S MANUAL CAREFULLY AND COMPLETELY BEFORE TRYING
TO OPERATE OR SERVICE THIS HEATER. IMPROPER USE OF THIS HEATER CAN CAUSE
SERIOUS INJURY OR DEATH FROM FIRE, EXPLOSION AND CARBON MONOXIDE POISONING.
SPECIFICATIONS
3
PROPANE TANK TOP HEATER
NEVER LEAVE THE HEATER
UNATTENDED WHILE BURNING!
”1.7
mc1.81
”11.2
mc4.82
”5.51
mc4.93
”3.8
mc0.12
”5.71
mc5.44
”5.6
m
c
6.41
12.0’’
30.5cm
MODEL
BTU OUTPUT
(high)
IGNITION TYPE
OPERATING
TIME (20 lb. cylinder)
TT-15CSA 15,000 Match 28 Hrs. (high) 33 Hrs. (med) 48 Hrs. (low)
TT-30CSA 30,000 Match
2 Burners: 14 Hrs. (high) 16 Hrs. (med) 24 Hrs. (low)
1 Burner: 28 Hrs. (high) 33 Hrs. (med) 48 Hrs. (low)