Use and Care Manual

CONNECTING HEATER TO PROPANE TANK
Read and understand all safety information before connecting heater to propane tank.
1. (Applies to dual burner models only). Place heater onto tank with tank collar bracket over tank collar (Fig. 1)
Mounting bolt knob should be positioned to the outside of tank collar and be positioned as closely as possible
directly opposite to the cylinder valve outlet. See Figures 1 and 2.
2. (Applies to dual burner models only). Firmly secure to tank by hand-tightening mountingbolt knob.
Do not overtighten mounting bolt knob.
3. Make sure heater regulator knob is in the OFF position.
4. Insert regulator’s connector into tank’s valve outlet tting and turn left (counterclock-wise) until fully tightened.
Threads are left-handed. (Figure 3.)
NOTE: Heater features a hand wheel that can be used to tighten the tting to the cylinder. No
wrench required.
5. Open propane tank valve slowly by turning counterclockwise .
6. Check all ttings for leaks. Apply a 50/50 mixture of liquid soap and water to all joints. Bubbles forming
show a leak. Correct all leaks at once.
7. Always remove propane tank from heater after each use. Do not store heater while attached
to propane tank.
WARNING: NEVER USE AN OPEN FLAME TO CHECK FOR LEAKS.
7
PROPANE TANK TOP HEATER
NEVER LEAVE THE HEATER
UNATTENDED WHILE BURNING!