Instruction manual

3 Assembling the stand
3.1 Assembling the stand components (Standard)
–
Assemble the individual stand components as shown in the
illustration.
–
Adjust the set screws 8 to insure the s tability of the stand.
Make sure that the stand is safe by insuring that every single foot
of the stand touches the ground.
3.2 Assembling the table plate
For an optimal arrangement, please respect the corresponding table
top layout:
Stand Table top layout
MG55 400364 0791 868710
MG55 400374 0791 868710
–
Screw the drawer 10 with its holders onto the left side under neath
the table plate.
–
Screw the oil sump 7 under the table plate.
The three stops of the oil sink should be fitted against the table
opening.
–
Screw the main switch 5* to the right side under the table plate.
–
Screw the cable duct 4* behind the main switch 5 under the table
plate.
–
Screw the holder 3 for the traction relief of the connecting cable
behind cable duct 4 under the t able plate.
–
Screw the sewing-lamp transformer 6 (optional equipment)
under the table plate.
–
Fit the machine head support 13** into the bore hole of the table
top .
–
Put the cap 15** into the bore hole of the table top.
–
Place the hinge bottoms 12 for the machine head into the cutout
of the table plate 11 and tighten the screws.
–
Insert the inclination support 14**.
–
Insert the rubber cor ners 2.
–
Attach the table plate 11 to the stand with woodscrews (B8 x 35)
(see sketch for position).
–
Insert the yarn stand 1 into the bore hole in the table plate and
secure it with the nuts and washers. Fit and align the yarn reel and
unwinding holders. The yar n reel holder and the unwinding arm
must be vertically in line.
–
Screw the holder for the oil-can 9 onto the left-hand stand brace
* Not applicable with sewing machines with direct drive.
** If the machine’s position in the stand should not be inclined but
horizontally straight, exchange position 13 against 15. Do not use the
inclination support 14.
7