Instruction manual
1
2
1
2
3
4
7
6
5
8
1
2
3
4
7
6
5
6
5
4.3 Fitting the sewing drive
–
Attach the sewing drive 2 with its base 1 on the bottom side of the
table plate by screwing the three hexagonal screws (M8 x 15) with
washers into the nuts 8 of the table plate bottom.
4.4 Fitting the pedal
–
Attach the pedal 4 to the stand brace 3.
–
For ergonomic reasons align the pedal 4 as follows:
The center of the pedal must be approximately under the needle.
There are slots in the stand brace 3 to help align the pedal.
–
Attach the ball pins to the lever 7 as required by the drive.
–
Hook in the pedal linkage 5.
–
Slightly undo screw 6.
–
Adjust the height of the pedal linkage 5 as follows:
when released the pedal 4 s hould be inclined about 10°.
–
Tighten screw 6.
10