Operation Manual

6.16 Lower edge trimming control

6.16.1 Switching on/off edge trimmer

Switch on

–

Push the knob (1) in the arrow (A) direction, or pull the handle (2)

in the arrow (B) direction until the trimming knife gets from the

initial position (3) to the switch on position (4).

–

Trimming mechanism drive starts up automatically when switched

on, and the trimming knife starts oscillating. The mechanism is

ready to trim (e.g. a lining) simultaneously with stitching.

–

When trimming the edge, direct the trimmed material under the

knife collar (5).

Switch off

–

Push the knob (1) downwards. The trimming knife turns from the

switched on position (4) to the initial position (3) and the trimming

mechanism drive switches off automatically.

Setting: see Service instructions