Operation Manual

6.16.3 Material guide adjustment

–

Adjust the guide element (1) height with a bolt (2). The guide

element is lifted, when tightening the bolt, and vice versa. If the

bolt (2) strikes the end of the adjustment range, the latter can be

widened by the bolt (3), loosening the plate (4) shifting to a

different position and its repeated fixing.

–

Adjust the lateral position of the guide element (1) by the bolt

loosening (5), the element shifting, and its repeated fixing.

–

Adjust the guide position in the sewing direction after loosening the

bolt (6). The rear edge of the guide element (1) should be located

in the needle hole center. After adjustment, tighten the bolt (6).