Operation Manual

6.17.2 Material guide adjustment

For a correct guiding of the sewn material against the trimming knife

a tipping guide can be used.

The guide can be lowered in the bottom position independent of the

trimming knife holder by pushing down of the control lever (1). Another

possibility is to switch the guide on and off simultaneously with the

switching on the edge trimmer main lever (2), which is ensured by

pushing down of the pin (3) in the upper (switched off ) position of both

levers.

–

With the lowered control lever (1), slightly loosen the bolt (4) and

with an Allen key (5) turn the bolt (6) to achieve the required lateral

position towards the trimming knife.

–

At the same time it is necessary to set the position of the guide (7)

in the sewing direction by its turning in the lever (1).

–

Set the suitable height of the guide over the throat plate by turning

of the setting bolt (8).

–

After adjusting the guide, tighten the fixing bolt (4).

For better guiding of the sewn material it is possible to use a retaining

part (9) attached to the guide (7), the height of which can be set up

after the fixing bolt (10) loosening.