Operation Manual

7. List of positioning motors (drives)
7.1 DAC basic/classic/eco
7.1.1 DAC basic/classic
DAC basic/classic control boxes are operated by means of the control
panel OP1000, which is a part of the motor equipment. The difference
between the basic and classic types of control boxes consists in the
number of connectable peripheries. The software is updated by means
of a separate DAC Dongle interface.
The control box can operate the minimotors M1-50 (500 W), M1-75
(750 W), or a direct drive installed on the sewing machine main shaft.
For the variant with the minimotor it is possible to choose the
installation on the sewing machine base plate and a toothed belt
transmission, or the minimotor installation under the table top and a
V-belt transmission. If the gear ratio is different from 1:1, an additional
proximity switch should be used.
A detailed description of the control box is included in the “DAC
basic/classic Operating manual“ supplied by the motor manufacturer
together with the sewing machine (see also
www.duerkopp-adler.com).
7.1.2 DAC eco
The DAC eco control box contains all necessary control elements for
the function switching and the parameter setting. The control panel
cannot be connected. The software is updated by means of a DAC
Dongle interface, which is common for the control pedal interface
connection.
The minimotor M1-75 (750 W) is joined with the sewing machine with a
toothed belt; it is possible to use a gear to achieve a higher torque.
Then an additional proximity switch should be used.
A detailed description of the control box is included in the “Operating
manual DAC basic/classic“ supplied by the drive manufacturer
together with the sewing machine (see also
www.duerkopp-adler.com).
41
EN