Operation Manual

4.7 Fitting the connecting cable, control panel and sewing diode lamp

on the machine head

–

A 37 pole connecting cable (1) is supplied with every sewing

machine equipped with a positioning motor.

–

The control panel (2) is an optional item of the Efka drives. If

ordered, it is always supplied with a holder (3). The control panel is

always an integral part of the DAC basic/classic drives.

–

A diode sewing lamp with a power LED-module (5) is an optional

item. Two types of holders are supplied with the module enabling to

mount the sewing lamp in two positions. The position (5) is basic.

The position (7) is used if a sewn material guide or the material

edge trimmer is installed on the machine.

–

Dismantle the upper and rear cover of the sewing machine head.

–

Install the connecting cable w ith the 37 pole connector (1)

according to the picture. Fix the cable ends against pulling out with

screws on the switchboard side and on the control box side.

–

Mount the control panel (2) with the holder (3) on and install its

cable (4) according to the picture.

–

Mount the sewing lamp (5) on and install its cable (6) according to

the picture. The power supply cable should be connected to the

transformer, which is supplied either separately, or, in the variant

with a direct drive, it can be a part of the switchboard.

–

Push the cables through the table top and attach them with a

self-sticking clip (8).