Operation Manual

5.4 Connection of machine head electric equipment to drive

A. The machine is equipped with the DAC basic/classic drive

–

Connect the sewing head connection cable into the connector (1)

signed with the machine symbol.

–

Connect the control panel into the connector (2) signed with the

panel symbol.

–

Connect the motor encoder connector into the connector (E).

–

Connect the motor connector into the connector (M).

–

Connect the pedal position sensor into the connector (3) signed

with the pedal symbol.

–

Connect “ machine identification” into the connector ID.

–

Connect the proximity switch to the connector (SYNC) if the sewing

machine has a gear ratio different from 1:1.

–

The connector (4) is used for the connection of other peripheries,

e. g. a knee lever or an electric hand wheel.

SYNC