Replacement Part List

Ⅲ. Operation before Starting Up

1. Connecting the water inlet

Connect the water inlet with a commercially available

hose, connector and fastener clip. The inlet hose must be a

continuous non-foldable structure with a length not more than

required and should be placed near to the source of water so as

to achieve the pump should be fitted to the end of the hose with

the hose connector as shown in the figure below.

CAUTION: Before pumping water, attach the filter to the end of

the hose to filter out foreign matters in the water, the presence

of which may cause clogging and damage to the wane wheel.

NOTE: The hose connector and fastener clip should be securely

fastened to prevent air leaks and reduction in suction power. A

loose hose will reduce the pump performance and self-suction

capacity.

2. Connecting the water outlet

Connect the water outlet with a commercially available hose,

hose connector and fastener clip. Large diameter hoses are the

most effective while small ones will increase the flow resistance

and reduce the output power of the pump.