Replacement Part List

OWNER’S MANUAL
-8-
5.INSTALLING GUIDE BAR AND SAW CHAIN
A standard saw unit package contains the items as
illustrated
(1) power unit
(2) Bar protector
(3) Guide bar
(4) Saw chain
(5) Plug wrench
(6) Hexagon wrench
Open the box and install the guide bar and the saw
chain on the power unit as follows:
a. Loosen the nuts and remove the chain cover.
b. Gear the chain to the sprocket, while fitting the saw
chain around the guide bar, mount the guide bar to
the power unit. Adjust the position of chain tension
nu
t on the chain cover to the lower hole of the
guide bar.
(1) Tensioner nut
(2) Chain cover
Pay attention to the correct direction of the saw chain
a. Mount the bar to the studs of the power unit, and
fit the saw chain around the guide bar, adjust the
position of chain tensioner nut on the chain.
b. Tighten the tensioner screw.
(Style 1 or Style 2）
(1) Tighten
(2) Loosen
(3) Tensioner screw
A new chain will expend its length in the beginning of use. Check and readjust
the tensi
on frequency as a loose chain can easily derail or cause rapid wear of
itself and the guide bar.
NOTE
NOTE
Style 1
（ 3
）
（1）
（
2）
Style 2