Owner`s manual

Owner’s Manual – Prodigy 3
8
H1250 1250 Rev. I
Lighting the Water Heater
The water heater must be lled with
water before lighting. Instructions for
lighting procedure are on the inside of
the access cover and shown below:
1. Rotate Gas control knob to OFF.
Wait ve minutes for unburnt gas to
vent. Note: L.P. Gas being heavier
than air, will not vent upwards
naturally.
2. Rotate gas control knob to “PILOT”.
Press and hold down.
3. Press ignitor button until pilot lights.
4. After 30 seconds release gas
control knob. If pilot goes out,
repeat steps 2 and 3.
5. When pilot stays alight, rotate gas
control knob to “ON”.
Warning: Wait ve minutes before
repeating ignition process.
Shutting Down The Water Heater
Turn gas control knob to position “OFF”.
Control Knob /
Reset Button
Test Point
Models with “Robertshaw” Gas Control
Gas Connections