Specifications

Installer’s Guide – Endurance six™
4
Part No: IG090701
Version: B

Water Connection
• Using correct plumbing methods,
connect the cold water pipe to the
heater.
Note: According to local regulations
and the plumbing code, t any
and all valves that are necessary
e.g. tempering valves, pressure
limiting valves, duo valves, cold
water expansion valves etc. We
recommend the use of new valves for
all Installation. Please refer plumbing
code and/or local requirements.
• A Gate Valve or Ball Valve must be
used on the cold water inlet to the
water heater.
This requirement is an Australia
wide requirement under the national
plumbing code.
• Stop taps or combination stop taps
and non-return valves are not to be
used!

Electrical Connection
• Continuous electrical power must
be supplied to the water heater. This
ensures correct performance of the
unit.
Installation Guide
Cold
Water
Inlet
Hot
Water
Outlet
240 Volt
Continuous Power Supply