User Manual

5
LEAD CHANNEL (tube)
8) GAIN – This knob sets the gain level of the LEAD channel. This is a tube channel that features four ECC83 preamp tubes. This control
will determine the amount of drive or saturation in your sound, ranging from crunch to overdriven lead sounds, or anywhere in between.
9) LOW – see (3).
10) MID – see (4).
11) HIG H – see (5).
12) PRESENCE – see (6).
13) MASTER – This control is the master feed from the end of the LEAD preamp channel to the solid state power stage. Thanks to the
independent Master controls for each channel, you can perfectly balance the levels of your CLEAN and LEAD sounds.
14) RIVERBERO – Level control for the onboard Accutronics® spring reverb.
15) PRE OUT / AMP IN – This loop is wired between the preamps and the power amp, and its level is optimized to match well with
most quality effect-processing devices. Simply connect the Pre Out jack to your processor’s input, and connect the output of your processor
to the Amp In jack. You can also use the Pre Out to send to another power amp, recording device, DI, etc.
16) FSW – 1/4” STEREO jack for connecting a DUAL footswitch for switching between the Clean and Lead channels, and for turning the
RIVERBERO on and off.
17) CLEAN / LEAD SWITCH – This channel selector switches between the Clean and Lead channels. Channel-switching can also
be controlled by the “Clean/Lead” footswitch that can be plugged into the combo’s top panel (17): the channel selector switch is disabled when
a footswitch is connected to the footswitch jack.