User Manual

6
AC POWER SOCKET Make sure the unit is grounded; all three terminals of the AC power plug must be connected to avoid any injury to the user or
damage to the unit
.
VOLTAGE SELECTOR The DV MICRO heads feature a 120V/240V Voltage Selector to use the amp in countries with different voltages, so
make sure the switch on the rear panel is on the correct voltage before connecting it to the AC power, and the fuse is the right value for that
voltage (not available on the 100V version manufactured for Japan).
Please change the voltage/fuse values label located near the voltage selector matching the voltage/fuse values when you need to change the
voltage of the unit.
FSW 1/4” MONO jack for connecting a SINGLE footswitch to switch between Clean and Lead channels.
SEND/RETURN The send/returncan be used for connecting with outboard effect processors or pedals. Simply connect the Send out to your processor’s
input, and connect the output of your processor to the Return in.
SPEAKER OUT The two speaker ouputs provided for speaker cabinet connections are wired in parallel and total minimum impedance load for the amp
is 4 ohms, so you can connect one or two 8 ohms speakers or only one 4 ohms speaker.
Use speaker cable (not instrument cable).
REAR PANEL - DV MICRO 60 - DV MICRO 60 CMT
SPEAKER OUT
MIN LOAD 4Ω
RETURN SEND
FSW
CLASS 2 WIRING
120
240