Service manual

39
Step 3 Fix Heatsink spacers onto Main Heatsink..
Caotion: Ensure that the Heatsink Spacers are properly
located and seated flatly onto Main Heatsink.
Step 4 Apply grease to the Main Heatsink as indicate in the dia-
gram.
Caution: Ensure Grease thickness is about 0.2mm.
Step 5 Upset the Main P.C.B..
Step 6 Fix 2 screws.
10.13. Disassembly of SMPS Module
and Voltage Selector P.C.B.
• Refer to “Disassembly of Top Cabinet.”.
• Refer to “Disassembly of Rear Panel”.
Step 1 Detach 13P Cable at a connector (CON2) on the SMPS
Module.
Step 2 Remove 2 screws.
Step 3 Remove the SMPS Module and the Voltage Selector
P. C .B ..
Caution: During assembling, ensure that SMPS Module is
seated properly through the located & fully guided.