Instruction Manual

7
19) SPEAKERS OUTS The amp offers the following speaker output jacks for connecting the head to a speaker cabinet or cabinets: two 8 ohm
(or, for one 4 ohm cab, use either of these jacks), two 16 ohm (or, for one 8 ohm cab, use either of these jacks) and one 16 ohm jack. Verify
the impedance of your speaker/s prior to connection, and make sure you are using the correct speaker output/s
20) VOLTAGE SELECTOR The DV Mark TRIPLE 6 III amp features a 120V/240V Voltage Selector (23) to use the amp in countries with
different voltages, so make sure the switch on the rear panel is on the correct voltage before connecting it to the AC power, and the fuse is the
right value for that voltage (This selector is not available on the 100V version).
Please change the voltage/fuse values label located near the voltage selector matching the voltage/fuse values when you need to change the
voltage of the apparatus.
21) AC POWER SOCKET Make sure the unit is grounded; all three terminals of the AC power cord must be connected to avoid any injury
to the user or damage to the unit.
CONTROLLER CH
SELECT
SENDSEND
LEVEL
DO NOT OPERATE THIS
AMPLIFIER WITHOUT
CONNECTING LOUDSPEAKERS
SPEAKER
OUT
TOTAL 4 Ω
OR 8 Ω + 8 Ω
LOAD
SPEAKER
OUT
TOTAL 8 Ω
OR 16 Ω + 16 Ω
LOAD
16 Ω
LOAD
SPEAKER
OUT
MIDI
IN THROUGH RETURNLOOP ASSIGN
CH1
CH2
CH3 ALL
OFF
ENABLE
0 dB
-15 dB
Model
TRIPLE 6 III
CAUTION:
FOR CONTINUED PROTECTION
AGAINST RISK OF FIRE
REPLACE ONLY WITH SAME
TYPE AND RATING FUSE.
ATTENTION:
REMPLACER UNIQUEMENT PAR
UN FUSIBLE DE MEME TYPE.
Ser.Nr.
Date
CH1
CH2
GAIN
0 MAX 0 MAX
MASTER
BASS MIDDLE HIGH
0 MAX
PRESENCE
GAIN
0 MAX
0 MAX
MASTER
BASS MIDDLE
HIGH
0 MAX
PRESENCE
GAIN
0 MAX
0 MAX
MASTER
BASS MIDDLE
HIGH
0 MAX
PRESENCE
CH3
STAND BY OFF
ON
ON
SOLO
TRIPLE SIX III
INPUT
15
1
2
3
4
5
6
8
9
7
2
3
4
5
6
7
2
3
4
5
6
7
10
11
12 13
14 16 17 18
19
20
21