Manual

FrtE Fuzzy Logic Rate of Change: Select 0.00 to 99.99 counts/second. For best
initial setting, find the counts/second change of process value near Set Point
1 with output ON 100%. Multiply this value by 3. Set FrtE to this
calculated value.
PEA The Peak feature stores the highest input the control has measured since
the last reset or Power On. At Power On PEA is reset to the present input.
To manually reset the value PEA must be in the lower display. Press the
ENTER key to reset. PEA will be reset and display the present input value.
UAL The Valley feature stores the lowest input the Instrument has measured
since the last reset or Power On. At Power On UAL is reset to the present
input. To manually reset the value UAL must be in the lower display. Press
the ENTER key. UAL will be reset and display the present input value.
Pct0 Percent Output Feature: Select 0n or 0FF.
0n When selected 0n, the HOME lower display will indicate the output
of the controller in percent. An “o” will appear in the right hand side
of the lower display to indicate percent output for SP1. An “ ” will
appear on the right hand corner of the lower display to represent
percent output for SP2, if the control is so equipped. The display
will alternate between these values.
0FF Percent Output display is disabled.
Pro9 Ramp/Soak Feature (16A3): Select 0n or 0FF.
0n Allows Programmed Ramp/Soak function to be started by the
Run/Hold key on the control front panel.
0FF Turns Ramp/Soak function 0FF and resets program to
beginning.
PSEt Programmer function set (16A3): Select 0n or 0FF.
0FF Skip Ramp/Soak Programming. Go to next Secondary Menu
Item,
1nPC on the next page.
0n Enable Ramp/Soak Programming.
StAt Programmer Status Display in the Primary Menu when Prog (above) is
On (16A3):
Select 0n or 0FF.
0FF The Primary Menu operates as normal.
0n The Primary Menu is altered to have the following items
inserted before the SP1 menu item:
#### ti time remaining in active segment
#### ##ti total time in active segment
#### ##SP segment target set point
es.
.9
e.
cool
onal
ned
al
nd
over-
time
gic).
e
band
1) for
o
~
Page 25
949-1265:Layout 1 1/25/11 10:23 AM Page 25