Manual

December, 1998 Page 21 of 28 949-1270
S2St Set Point 2 State: Select Eng or dEng.
Eng Output Energized. The output device (per Order Code)
will be energized at set point. (Normally Open contacts
will close, Normally Closed contacts will open.)
dEng Output De-energized. The output device (per Order
Code) will be de-energized at set point. (Normally Open
contacts will open, Normally Closed contacts will close.)
S2LP Set Point 2 Lamp: Select O on or OoFF.
O on Lamp ON when Output is ON (energized).
OoFF Lamp OFF when Output is ON (energized).
SPSA (Option 948, 4-Stage Set Point) Switch Action: Select rE or Int.
rE Set Point Stage selected by external contact closures.
Int Set Point Stage selected by internal menu selection. See
SP menu item in Secondary Menu.
Addr (Option 992, 993, Serial Communications) Control Address: Set
from 1 to 3FF. This number (hexadecimal, base 16) must match the
address number used by the host computer.
bAUd (Option 992, 993, Serial Communications) Communication Baud
Rate: Select 300, 1200, 2400, 4800, 9600, or 19200. This number
must match the baud rate used by the host computer.
nAt (Option 992, 993, Serial Communications) No Activity Timer: Set
from OFF or 1 to 99 minutes.
1 - 99 Maximum time between host computer accesses. If timer
counts to 0, CHEC/LorE will be displayed.
OFF No Activity Timer function is disabled.