Manual

Chapter 1 Introduction
The 3200 Smart Pressure Transmitter is calibrated at the factory
before shipping. To ensure correct and efficient use of the
instrument, please read the manual thoroughly and fully understand
how to operate the instrument before operation.
1. The contents of this manual are subject to change without prior
notice.
2. All rights reserved. No part of this manual may be reproduced in
any form without Dwyer Instruments, Inc. written permission.
3. If any question arises, errors are found or if any information is
m
issing from this manual, please inform Dwyer Instruments, Inc.
4. The specifications covered by this manual are limited to standard
transmitters and do not cover custom-made instrument.
5. Please note that changes in the specifications, construction, or
component parts of the instrument may not immediately be
reflected in this manual at the time of change, provided that
postponement of revisions will not cause difficulty to the user from
a functional or performance standpoint.
1.1 Using This Manual
The operating manual provides information on installing, operating,
and maintaining the Mercoid
®
Model 3200 Smart Pressure
Transmitter. The Chapters are organized as follows.
Chapter 2 Handling Cautions
Chapter 2 provides instructions on commissioning and operating
Model 3200 Smart Pressure Transmitters. Informations on software
functions, configuration parameters, and on-line variables are also
included.
Chapter 3 Transmitter Functions
Chapter 3 contains suggestions on handling the Model 3200 Smart
Pressure Transmitters.
Chapter 4 Installation
Chapter 4 contains mechanical, environment consideration and
electrical installation instructions for the Model 3200 Smart Pressure
Transmitters.
Chapter 5 On-line Operation
Chapter 5 describes how to configure the parameters of the Model
3200 Smart Pressure Transmitter. See the following list for the
details.
1. Regulations of circuit's Input/Output characteristics; Sensor or
Output Trim
2. Changing the output characteristic; Range Configuration, Output
Type, Dampening, Unit
3. Changing the general data; Tag No., Date, Message, etc.
Chapter 6 Maintenance
Chapter 6 contains hardware diagnostics, troubleshooting and
maintenance task.
1.2 Overview of Transmitter
The Mercoid
®
Smart Pressure Transmitter is a microprocessor based
pressure transmitter with a capacitance sensor optimized for draft
measurement. The Model 3200 has a true draft analog range from 0
to 20 mA. This transmitter is explosion-proof, high precision
accuracy, reliability and has digital communication for remote
communication system.
The Model 3200 is enabled with HART
®
communication with Host,
HHT (HART
®
Communicator) or PC Configurator. The transmitter’s
various variables in host are able to be changed, configured and
calibrated by users. The HART
®
Communication between DC power
s
upply and transmitter requires a 250~ 550 Ohm resistance.
1.3 Software Compatibility
The Mercoid
®
Smart Pressure Transmitter's software is implemented
at the factory. The following functions can be configured using a HHT
(HART
®
Communicator).
● : Supported.
∆ : Supported but update required
Page 2
Function
ZERO/SPAN
ZERO TRIM
ZERO Adj
Units set
Range set
Dampening set
LCD Decimal set
ZERO/SPAN Button
Rev. 58
●
●
●
●
●
●
●
PC/PDA
●
●
●
●
●
●
●
HART HHT
●
●
●
●
●
●
∆
Function Supports