Installation Sheet

- 4 -
In the United States:
DXV
One Centennial Avenue
Piscataway, New Jersey 08855
Attention: Director of Customer Care
For residents of the United States, warranty
information may also be obtained by calling
the following toll free number: [phone]
www.DXV.com
In Canada:
DXV
5900 Avebury Road
Mississauga, Ontario
L5R 3M3
Canada
Toll Free: 1-800-387-0369
Local: 905-306-1093
Fax: [phone]
www.DXV.ca
In Mexico:
DXV
Via Morelos 330
Col. Santa Clara Coatitla
Ecatepec, Estado de México 55540
Toll Free: 01-800-8391200
www.DXV.mx
7302314-100 Rev. B (6/17)
COMPONENT NUMBER DESCRIPTION
D23040A000.415 With seat
5026A.10G.415 Seat
D29000000.000 Geberit In wall carrier
D28030000.415 Geberit square button dual ush plate
D29054026.000 Grohe In wall carrier
D28015000.415 Grohe dual ush plate
(for carrier repair parts please check carrier installation instructions)
Seal gap around bowl with waterproof sealant.
6i
6h
Install both seals into the pipes in the wall. Lubricate seals
with appropriate rubber seal lubricant.
Remove protective sleeves from threaded mounting rods.
Install rods with a protruding length of 1-3/8" (35 mm) from
the nished wall. Then install the threaded nuts leaving
approximately 3/8" (10 mm) of the threaded rod exposed.
Also insure the concave portion of the nut is facing down!
Install both pipes into the hubs in the wall.
6f 6g
3/8"
(10 mm)
Ensure each of the pre-installed 4 ngered plastic mounts
are securely mounted into each mounting hole of the toilet.
Place bowl onto female threaded nuts and carefully insert
bowl so the threaded female nuts go into the plastic nger
housings mounted in the toilet. Once toilet is fully mounted
into the female threaded nuts, turn the hex allen rod insert-
ed into the plastic housing clockwise to tighten toilet into
nished wall.
Female
Thread Nut
Concave
4 Fingered
plastic
mount
Hex allen
rod
Hex allen
handle