Use and Care Manual

Sun Paints & Coatings / Dyco Paints • 5850 Ulmerton Road • Clearwater, FL 33760
Phone: [phone] • Facsimile: 727.536.0561 • www.SunPaintsAndCoatings.com
B-15
R-1i
DYC9040
TUFF GRIP BONDING COAT
9040 Data Sheet
CHARACTERISTICS
Tuff Grip Bonding Coat is a waterborne epoxy ester tie coat
formulated to penetrate, fortify and prepare slick steel
troweled non-porous bare concrete and cured asphalt.
This product is also a superior bonding primer for previ-
ously painted deck surfaces.
RECOMMENDED USES
Deck Coating Bonding Primer for:
•
Bare Concrete Decks
•
Cured Asphalt Surfaces
•
Previously Painted Deck Surfaces
FEATURES/BENEFITS
•
Excellent Alkali Resistance
•
Forties and Reinforces
•
Superior Adhesion to Bare Concrete
•
Low VOC’s
•
Easy Soap and Water Clean Up
SPECIAL NOTES
New Concrete must be fully cured, 30-45 days Surface
must be clean and dry air temperature should be at least
50°F (10°C). Product must be Top Coated within 5 Days
For a non-skid surface use Dyco #44 Skid Gard Do not ap-
ply this product to a Bomanite Surface
FOR ADDITIONAL INFORMATION
See MSDS or call toll-free 1-800-282-7901.
TECHNICAL DATA
Vehicle Type ...................... Waterborne Epoxy Ester
Finish/Sheen .................... Low
Solids by Weight ................ 29%
Solids by Volume ............... 25%
Viscosity ........................... 80 ± 2 KU
VOC
(less exempt solvents)
............. 310 g/L.
Weight per Gallon .............. 8.64 lbs/gal.
COVERAGE
350 S.F./Gal. @ 4 mils Wet; 1.44 mil DFT
(Actual coverage may vary depending on type of sub-
strate, and application method.)
COLOR
•
9040 Transparent Amber
KEY ATTRIBUTES
Application Temperatures: 50 - 110°F (10 - 43.33°C)
Application Tools: Brush, Roller, or Spray
Dry Times: Touch - 2-3 Hour; Recoat - 8 Hours
(Dry Time Based on 77°F (25°C), 50% RH)
Thinner: 8oz. per gallon max. for non-porous concrete.
Clean Up: Warm Soapy Water
PHYSICAL PROPERTIES
Mildew Resistance ..Excellent
Flash Point ..............145°F (62.77°C)