Installation Guide

5
Faucet Installation Steps
3. Wrap the threads on one end of the bases
with pipe tape. Screw the bases into the
female fittings.
Reinforce the bases to the floor by using
self-tapping screws.
4. Install two seal washers into couplings.
Align bases with inlets of floor supplies
couplings. Thread couplings to bases.
Slide floor escutcheons down to the base
of the floor supplies until flush with the
floor. Install the hose to the hand shower
and the tub filler. Confirm tub filler spout
and hand shower functionality.
a. Turn tub filler cross handle to the ON
position initiating flow through the tub
filler spout.
b. Confirm proper Hot and Cold flow
through spout.
c. Remove the hand shower from the
house and direct towards the bath.
d. Turn the diverter lever to direct flow
from the spout to the hand shower.
e. With water now flowing through the
hand shower check all hand shower
house connections for leaks and confirm
proper flow through the hand shower.
f. Turn tub filler lever handle OFF.
www.dyconnfaucet.com