Installation Guide

1. Remove the screw from the front of the unit to connect the power to the heater.

2. Attach the cable connectors to the unit (See Figure 6) and slide the

10- gauge wire through the cable connector.

NOTE: All wiring must be accordance to national and local electrical codes in the

United States. For certain applications conduit may be required See Figure6. Check

local electrical codes. If you run the wiring in conduit and wish to be able to turn the

heater be sure to purchase enough exible conduit to allow the heater to be turned.

3. Connect the wire to the power block located in the base of the heater - See Figure 7.

4. Turn on the power at the main service.

CAUTION:

High temperatures – risk of re. Keep ammable materials, such as furniture, pillows,

bedding, papers, clothes and curtains at least 3 ft. (0.9 m) from the front and top of the

heater and keep them away from the sides and rear.

To reduce the risk of re, do not use it in areas where gasoline, paint or ammable

liquids are used or stored.

This appliance must be grounded!

The appliance must connect to a current protection circuit or device at 50Amp or

less before being connected to power supply!

WARNING