Installation Guide

THERMOSTATIC CONTROL OPERATION (SELECT MODELS)

The thermostat used on this heater senses the room tempera-

ture. At times the room may exceed the set temperature. If so,

the burner will shut off. The burner will cycle back on when

room temperature drops below the set temperature. The control

knob can be set to any comfort level between "HIGH" (5) and

"LOW"(1) (See Fig. 25).

MANUAL CONTROL OPERATION

Manual valves remain burning in the desired setting until manu-

ally turned to OFF " "(See Fig. 25).

Fig. 25 - Control

Knob Position

ManualThermostatic

OPERATION

INSPECTING BURNERS

Check pilot ame pattern daily when in use and at least yearly by a qualied service agency.

PILOT FLAME PATTERN

Fig. 26 shows a correct pilot ame pattern. Fig. 27 shows an incorrect pilot ame pattern. The incor-

rect pilot ame is not touching the thermocouple. This will cause the thermocouple to cool, which

shuts the heater off. If pilot ame pattern is incorrect:

• turn heater off (see “To Turn Off Gas to Appliance” on page 19)

• see Troubleshooting pages 23 through 26.

Fig. 26 - Correct Pilot Flame Pattern Fig. 27 - Incorrect Pilot Flame Pattern