Instructions / Assembly

9
AA
HH
M6x12 Bolt
x 4
x 1
ASSEMBLY INSTRUCTIONS
5. Use one M6X26 bolts (EE) and one M6 wing
nut (FF) to assemble the Tank Retention Bracket
(P) to Tank Retention support Bracket (Q).
Fasten Tank Retention Bracket (P) and Tank
Retention support Bracket assembly (P+Q) in
the Cart Right Upper Brace Assembly (S)
by using two M6x18 bolts (GG).
6. Insert one of the end of cylinder block bar (X)
into the hole on the bottom of front
panel, insert the other end with thread onto
the Cart Rear Lower Brace Assembly (I). Use
one M5 wingnut (HH) to fasten the cylinder
block bar (X) onto the Cart Rear Lower Brace
Assembly (I). Use four M6x12 bolts (AA) to
fasten the Cart Rear Lower Brace Assembly(I)
onto the two rear leg assembly.
Note: Follow the arrow direction on the Cart
Right Lower Brace Assembly (I) when install.
DO NOT TIGHTEN BOLTS AT THIS TIME.
5
6
Hardware Used
EE
FF
GG
M6x26 Bolt
M6x18 Bolt
M6 Wingnut
x 1
x 1
x 2
AA
P&Q
X
HH
I
Hardware Used
GG
EE
Q
P
S
FF
Cotter pin
Wheel axle
Cotter pin
Wheel axle
Cotter pin
Wheel axle
M5 Wingnut
Cotter pin
Wheel axle
Cotter pin
Wheel axle