Full Product Manual

ASSEMBLY INSTRUCTIONS

15. Insert the end of the grease cup support (M) into

the hole located on the bottom of the smoker

body (C). Thread the support through the hole

until the support is hanging as shown.

Note: This grill does not include a container for

catching grease or liquids from inside the smoker

body. Use a discarded aluminum can with

minimum diameter of 2 1/4" (58mm) and slide

the top lip of the can onto the grease cup support

(M) as shown. See Page 3 for disposing the can

after use.

16. Attach the right shelf bracket (N) to the grill

body (C), using two M6 x 12 bolts (AA) and two

M6 nuts (BB), and insert the shelf support wire

into the bracket, as shown. Insert the shelf

supports into the left shelf bracket (O), before

securing the bracket with two M6 x 12 bolts (AA)

and two M6 nuts (BB).

Hardware Used

M6 x 12mm

Bolt

x 4

M6 Nut

x 4